air brakes

CDL Air Brakes Practice Test with Answers and Explanations (2026)

Free CDL air brakes practice test with answers for 2026: sample questions, explanations, the 80% pass mark, and the PSI values the DMV expects you to know.

air brakes practice test L restriction knowledge test CDL

The air brakes test is part of the CDL written exam in most states. You take it because the truck or bus you plan to drive uses air brakes. Pass it, and your license will not carry the “L” restriction.

This page works like the real test. Each sample question includes the correct answer and a plain explanation. Use it along with the free CDL air brakes practice test to build speed before exam day.

What the Air Brakes Test Covers

Every state writes its air brakes questions from the official CDL manual. The topics come from federal rules in 49 CFR 383.95:

  • The parts of the air brake system: compressor, governor, reservoirs, valves, chambers, and slack adjusters.
  • How air builds up and is stored under pressure.
  • Brake lag and why stopping distance grows.
  • The warning devices and emergency brakes.
  • The PSI numbers used during the air brake check.

You do not need to be a mechanic. You need to understand what each part does and what three or four key numbers mean.

CDL Air Brakes Practice Questions

1. When the air tanks reach the governor’s cut-out point, the compressor:

  • A. Keeps pumping at full power
  • B. Stops pumping air
  • C. Releases air from the tanks
  • D. Doubles its speed

Correct answer: B. The governor tells the compressor when to stop building pressure. Cut-out happens around 100 to 125 psi.

2. Air brakes take about half a second longer to work than hydraulic brakes. This delay is called:

  • A. Friction lag
  • B. Brake lag
  • C. Pressure fade
  • D. Reaction time

Correct answer: B. Brake lag is the delay between pressing the pedal and the brakes applying. At 55 mph it adds roughly 32 feet of stopping distance.

3. The low air pressure warning light and buzzer must turn on before the pressure falls below:

  • A. 100 psi
  • B. 80 psi
  • C. 60 psi
  • D. 40 psi

Correct answer: C. Federal rules require the alarm at 60 psi or higher. Never drive once the alarm sounds.

4. With the engine off and the foot brake pressed, single vehicles may lose no more than:

  • A. 1 psi per minute
  • B. 3 psi per minute
  • C. 5 psi per minute
  • D. 10 psi per minute

Correct answer: B. The limit is 3 psi in one minute for a single vehicle. Combination vehicles may lose up to 4 psi in one minute.

5. Spring brakes on an air-brake system apply automatically when air pressure drops to about:

  • A. 120 psi
  • B. 90 psi
  • C. 20 to 40 psi
  • D. 5 psi

Correct answer: C. The spring (parking) brake valves pop out between 20 and 40 psi. This is the automatic emergency stop.

6. Which part stores the compressed air for the brake system?

  • A. The compressor
  • B. The governor
  • C. The air reservoirs
  • D. The slack adjusters

Correct answer: C. Reservoirs, also called tanks, store the air. The compressor creates it and the governor controls it.

7. The air compressor is usually driven by:

  • A. The engine
  • B. The wheels
  • C. The transmission
  • D. An electric motor

Correct answer: A. The compressor runs off the engine. If the engine stalls, no new air is produced.

8. On a long downhill grade, the safest way to control your speed is to:

  • A. Ride the brakes the whole way down
  • B. Use a low gear and brake in short bursts
  • C. Pump the brake pedal fast
  • D. Turn off the engine

Correct answer: B. Constant braking overheats the brakes and causes fade. A low gear and short applications manage heat and speed.

9. Brake fade happens when the brakes:

  • A. Get too cold
  • B. Overheat from heavy use
  • C. Lose air slowly
  • D. Are new

Correct answer: B. Heat from repeated braking reduces brake power until the truck barely stops.

10. The yellow knob on the dashboard controls the:

  • A. Trailer brakes
  • B. Emergency flashers
  • C. Parking brakes
  • D. Air dryer

Correct answer: C. The yellow (parking) knob and the red (trailer) knob control the spring brakes.

How the Test Is Scored

Most states use 25 questions for the air brakes test. You need 80% to pass, which means at least 20 correct answers out of 25. A few states use a different count, so confirm yours in the official CDL manual for your state.

Pass It on Test Day

  • Memorize the four numbers: 100-125 (normal range), 60 (warning), 3 (psi loss per minute), 20-40 (springs pop out).
  • Read each question twice. The test often asks what happens FIRST or what to do NEXT.
  • Never pick “ride the brakes” or “pump the pedal fast.” Both are wrong on downgrades.
  • Drill daily with the free air brakes practice test and the general knowledge practice test.

Review the full written exam with our CDL written test study plan.

Frequently Asked Questions

Do I need the air brakes test for a Class B license?

Only if the Class B vehicle you will drive has air brakes. The rule follows the vehicle, not the class. See who must take the air brakes test by class.

What happens if I do not pass it?

You can still get a CDL, but it will carry an “L” restriction. That restriction means you cannot operate an air-brake-equipped vehicle.

Is the air brakes test an endorsement?

No. It removes the “L” restriction; it is not an endorsement like H, N, P, S, or T. Read about the air brakes test and the L restriction.

Official Sources

The air brakes knowledge test requirements are defined in 49 CFR 383.95. General CDL licensing rules are explained on the FMCSA CDL page. State exam details come from each state’s CDL manual via AAMVA.

Numbers reflect federal rules and the Model CDL Manual. Confirm your state’s exact format before test day.

Ready to put this into practice?

Take a free CDL practice test — or let the AI tutor quiz you on any subject, in any language.

Back to all articles